OBSERVE. ANALYZE. ACT.
Support Login

FlowMagic NextIO Components

FlowMagic Validation Tools Components

Choose validation components and open their topology, settings, setup, measurements, and troubleshooting guides.

UI Path: NextIO Diagram Editor → Components → Validation Tools ID: nextio-flowmagic-validation-components

Open a component guide for its topology, settings, setup procedure, measurements, troubleshooting, and complete field reference.

Choose A Validation Component

Component Use it to Connect it to
Test Project Identify a test, coordinate its lifecycle, record measurements, and evaluate acceptance rules. No packet connections; it applies to the service.
TestPort Attach workloads to a physical traffic port and measure port activity. A test workload through its numbered queue pad.
Test Hosts Prepare IPv4 host populations, provide network services, and run client/server activities. One TestPort queue through the Network pad.
Stateless Packet Generator Send a controlled Ethernet/IPv4/UDP stream in a compatible saved design. TestPort on Wire and a retained HostPool on Hosts; see the current limitation below.
RFC2544 Benchmark Search for forwarding throughput using saved packet sets. One dedicated TestPort for loopback, or two for a port-pair test.
PCAP Replay Replay captured packets through selectors, modifiers, and named outputs. A downstream packet path, such as WAN Emulator or Output Port.
WAN Emulator Apply a saved timeline of delay, loss, bandwidth constraints, and other impairments. Exactly one input and one output for each directional path.

Test Project

Own the run's identity, recording policy, sampling, completion grace, and selected Validation Rules. This component has no packet pads. Review execution, recording completeness, and acceptance as separate aspects of the result.

Read the Test Project guide.

TestPort

Select the physical interface, connect matching workload queues, and configure MTU and packet storage. TestPort measurements describe the physical attachment; the workload defines the traffic behavior.

Read the TestPort guide.

Test Hosts

Prepare host populations, configure DHCP/DNS or static addressing, and assign client/server activities from Validation Models. The client and server profile bindings are explicit.

Read the Test Hosts guide.

Stateless Packet Generator

Generate a controlled untagged Ethernet/IPv4/UDP stream in an existing compatible design. The current generator supports one lane and a configured load up to 100 Mbps.

Current limitation: Wire requires a single-queue TestPort, and Hosts requires a retained HostPool. HostPool is hidden from the current palette; Test Hosts is not a substitute, and a generator/TestPort-only design is incomplete.

Read the Stateless Packet Generator guide.

RFC2544 Benchmark

Run a forwarding-throughput search using Packet Database packet sets and dedicated TestPorts. Review directional trials, achieved wire rates, and measurement validity before interpreting the search result.

Read the RFC2544 Benchmark guide.

PCAP Replay

Replay PCAP/PCAPNG sources through selectors, modifiers, and named output pads. Configure merge timing, pacing, finite completion, and runtime Pause/Resume or exposed rate changes.

Read the PCAP Replay guide.

WAN Emulator

Apply a saved WAN Emulation Profile to one directional packet path. Configure profile playback and enough completion grace for delay/backlog, with a separate emulator when reverse traffic also needs impairment.

Read the WAN Emulator guide.